Sony RM-AV2100B - Manual (Page 32)

32
Adding a command that is
required when selecting a
component
In addition to the original function of
selecting the operating keys and buttons
of the desired component, the
Component Select button can have
another remote control signal by
“learning.”
For example, if you always have to
change input select of the amplifier to CD
when listening to the CD player, program
the signal of “changing the amplifier’s
input select” to the CD button of this
Commander. Then whenever you press
the CD button, it automatically works as
the original CD Component Select button
and changes also the amplifier input
select to CD. (In this case, the amplifier
should be turned on first.)
Note
Some specific remote control signals may not
be learned.
Notes
• If the component code of a non-Sony product
has been set for a Component Select button,
you cannot program the Power-On function
for it.
• Even if you have programmed a signal by
“learning” (See “Adding a command that is
required when selecting a component.”) or a
System Control function (page 28) for a
Component Select button, you can program
the Power-On function for that button, but it
cannot be used. If you clear a “learned”
signal or the System Control function from
the button, you can use the Power-On
function.
• You can program a signal by “learning” (page
32) or a System Control function (page 28) for
a Component Select button for which the
Power-On function has been programmed. In
this case, the Power-On function is
overwritten and cannot be used. If you clear
the “learned” signal or the System Control
function from the button, the Power-On
function is resumed, and you can use it again.
If you have programmed both a signal by
“learning” and a System Control function for
the button, the “learned” signal will have
overwritten the System Control function.
Adding an Extra Function to the
Component Select Buttons
(continued)