Sony RM-AV2100B - Manual (Page 25)

25
3
Press key(s) or button(s) for the
desired operation.
If you want to power on the TV, press
the POWER (or POWER ON) key.
4
Repeat Steps 2 and 3 and
program the buttons and keys for
the series of operations.
In this example, press the following
buttons and keys.
5
When you have programmed all
the keys, press COMMANDER
OFF.
Continued
Notes
• If you interrupt the procedure at any point
for over two minutes, the setting mode ends
and the series of commands will be
programmed to that point. In this case, clear
the program (page 26) and start again from
Step 1 to set the entire program from the
beginning. You cannot continue from where
you let off.
• If a SYSTEM CONTROL button has already
“learned” a remote control signal (see page
38), “NG”flashes and you cannot program on
this button. Clear the learned contents first
(see page 40).
•If you change the component code number
(page 8) or program a new signal by learning
(page 16) on a key or button that has been
programmed in the series of commands of
the System Control function, the new signal
will be transmitted when you press the
corresponding SYSTEM CONTROL button.
• During Setting mode, the RESET key is not
displayed and you cannot clear any operation
step you have programmed. If you have
programmed an incorrect operation by
mistake, start again from Step 1.
Tips for programming the
System Control functions
The following information helps you to
program a consecutive operation steps.
About the interval between
operation steps
You can change the interval between operation
steps (see page 30).