Sony RM-NX7000 - Manual (Page 224)

224
Remote Commander information (ABOUT)
You can check the system information (used memory capacity, version, etc.) of
the Remote Commander in the display.
1 Press the [SET] key for 2 seconds or longer in the
Home display.
The Set display appears.
2 Press the [SYSTEM] key.
The System display appears.
3 Press the [ABOUT] key.
The system information display appears.
The version of the Remote Commander is shown in the “System” item in
the information.
4 After checking, press the [OK] key.
The display returns to step 3.
5 To finish all settings, press the COMMANDER OFF
button for 2 seconds or longer.
The display returns to the Home display. Or press the [EXIT] key
repeatedly until the Home display is shown.