Symantec Veritas 5 - Manual (Page 115)

5 To view additional information about LLT, run the lltstat -nvv command
on each node.
For example, run the following command on the node galaxy in a two-node
cluster:
lltstat -nvv | more
The output on galaxy resembles:
Node State Link Status Address
*0 galaxy OPEN
eth1 UP 08:00:20:93:0E:34
eth2 UP 08:00:20:93:0E:34
1 nebula OPEN
eth1 UP 08:00:20:8F:D1:F2
eth2 DOWN
2 CONNWAIT
eth1 DOWN
eth2 DOWN
3 CONNWAIT
eth1 DOWN
eth2 DOWN
.
.
.
31 CONNWAIT
eth1 DOWN
eth2 DOWN
Note that the output lists 32 nodes. The command reports the status on the
two nodes in the cluster, galaxy and nebula, along with the details for the
non-existent nodes.
For each correctly configured node, the information must show the following:
■ A state of OPEN
■ A status for each link of UP
■ An address for each link
115 Verifying the VCS installation
Verifying LLT, GAB, and cluster operation