SUPER MICRO Computer 6113L-8 - Manual (Page 38)

S UPER S ERVER 6113L-8/6113L-i User's Manual
5-2
!
5-2 Itanium2 Processor and Heatsink Installation
When handling the processor package, avoid placing direct pressure
on the label area of the fan. Also, do not place the serverboard on
a conductive surface, which can damage the BIOS battery and
prevent the system from booting up.
IMPORTANT: Always connect the power cord last and always remove it before
adding, removing or changing any hardware components. Make sure that you
install the processor into the CPU socket before you install the CPU heatsink.
To optimize the functionality and capability of the i2DML-8G2/i2DML-iG2, we
recommend it be installed in Supermicro chassis only.
Warning: The heatsink on the MRH-D chip has been pre-installed by the
manufacturer. Please do not touch it. Turning the heatsink the wrong way will
damage it and will void the manufacturer's warranty.
Locating the Components
Locate the following components, which are included in the shipping package.
!
Two (2) power pods (VRM-0008)
!
Two (2) Itanium2 heatsinks (SNK-0046)
!
One (1) heatsink retention package, which includes:
One (1) heatsink retention mechanism (SKT-0147-RM-IT2)
Eight (8) 5-mm M3 screws
Three (3) 6-32, 4.5-mm screws
Six (6) 6-32 9-mm screws
One (1) M2.5 hex key (for CPU removal and locking)