Sony SPP-933 - Manual (Page 16)

Basics 16 US
1
Pick up the handset from the
base phone.
2
Press (TALK).
The TALK/BATT LOW lamp on
the handset and the LINE lamp
on the base phone light up.
Then you’ll hear a dial tone. If
you hear error beeps, move
closer to the base phone.
3
Dial the phone number.
4
When you’re done talking, press
(OFF) or replace the handset on
the base phone.
The TALK/BATT LOW lamp on
the handset and the LINE lamp
on the base phone go off.
To
Put a call on hold
Select a better channel
Adjust the handset
volume
Switch to tone dialing
temporarily
Switch to another call
(“call waiting” service*)
* You need to subscribe to the service from your telephone company.
Basics
Making calls
Additional tasks
Notes
• Before dialing, make sure you can hear the dial tone, otherwise you cannot
dial correctly.
• When the TALK/BATT LOW lamp repeats a set of two flashes, the base
phone is in use.
• When you set the handset volume to H (high), the volume will be raised
considerably. Under normal circumstances, set the volume to M (middle).
Do this
Press (HOLD).
The TALK/BATT LOW lamp flashes slowly.
Press (TALK) to resume the conversation.
Press (CHANNEL).
Set the VOL switch to H (high), M (middle) or L
(low).
Press (*TONE) while using the telephone after
you’re connected.
The line remains in tone dialing until disconnected.
Press (FLASH) to access the flash function.
Press (FLASH) again to return to the first caller.
(REDIAL/PAUSE)
(*TONE)
TALK/BATT
LOW lamp
VOL
switch
(CHANNEL)
(HOLD)
(FLASH)