SUUNTO D6I - Manual (Page 53)

5.9.3. Setting the tank pressure pairing
In the Tank Pressure Pairing setting mode, the wireless transmission can be set “ON”
or “OFF” depending on whether the wireless pressure transmitter is used or not. When
the wireless transmission is set “OFF”, no cylinder pressure-related data is shown,
nor data reception made. The Code setting allows you to verify the selected transmitter
code and to clear the stored transmitter code. Clearing the code enables re-pairing
with the transmitter, which can be necessary if a new transmitter or used, or if several
divers are using the same transmitter code.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.9.4. Setting the tank pressure alarm
The tank pressure alarm can be set "ON" or "OFF" and in the range of 10–200 bar.
The alarm is the secondary cylinder pressure alarm point. The alarm is activated when
the tank pressure drops below the set limit. You can acknowledge this alarm.
The 50 bar/700 psi alarm, however, is fixed and cannot be changed. You cannot ac-
knowledge this alarm.
54