SUUNTO D6I - Manual (Page 47)

5.8.3. Transmitting data
After the pairing procedure, the Suunto D6i will receive cylinder pressure data from
the transmitter. The pressure is displayed in either bars or psi, depending on the unit
selected. Any time the Suunto D6i receives an appropriate signal, a flash symbol is
displayed in the lower left corner.
Table 5.4. Pressure transmission related displays
Figure Indication Display
A Set Code. No code stored, Suunto D6i ready for pairing with
transmitter. Cd:--
B Set Code. Code number can be between 01–32. Cd:10
C Pressure reading over 360 bar/5220 psi. - - -
D Pressure reading has not been updated for more than one minute.
The latest valid pressure reading is displayed intermittently.
Transmitter is out of range, in power saving mode or on another
channel. Activate the transmitter by breathing off the regulator,
and assign a new code to the Suunto D6i unit if necessary. no conn
E Pressure transmitter battery voltage is low. The pressure reading
is displayed intermittently. Change the transmitter battery! batt
48