Sony RM-AX5000 - Manual (Page 8)

8
Recharging the battery
using the Battery
Charging Stand
This unit can be recharged using the supplied
Battery Charging Stand.
Tip
When you lift the Remote Commander off the Battery
Charging Stand, a beep sounds and the button
illumination and display are lit.
1
Connect the AC Power Adaptor plug to
the DC IN 6 V jack on the rear of the
Battery Charging Stand.
Insert the cable along the groove on the bottom
of the Battery Charging Stand.
2
After matching the Remote Commander
terminal and the Battery Charging Stand
terminal, place the Remote Commander
on the Battery Charging Stand.
Charging starts when the CHARGE indicator is
lit with a beep sound. Charging is completed
when the CHARGE indicator turns off.
This unit can be placed on the Battery Charging
Stand either face down or face up.
When the Remote Commander is placed on the
Battery Charging Stand, display and button
illumination automatically turn off with a beep
sound.
Note
Place the Battery Charging Stand on the level
surface.
If the Battery Charging Stand is unstable or terminal
is disconnected, charging will not start. Check the
CHARGE indicator is lit.
To detach the Rear
Cover
1
Slide and open the Rear Cover until it stops.
CH AR GE
OP EN
2
Remove the Rear Cover while pressing
the tab.
CH AR GE
OPEN
CHARGE indicator
CHARGE indicator