Installing, Install lift arms, Install blade – John Deere OMGX10902 I0 User Manual
Page 8: Install lift links to blade frame and lift arms
![background image](/manuals/130377/8/background.png)
Installing - 4
INSTALLING
Installing
Install Lift Arms
NOTE: Align the machine directly behind the blade
assembly before parking the machine.
1. Park the machine safely. (See Parking Safely in the
Safety section.)
2. Install one 1/2 x 1-1/2 x 3/16 in. flat washer (A) onto the
pin of each lift arm (B).
3. Insert the blank end of the lift arms behind the guide
rods (C) of the machine lift at each side of machine.
NOTE: The lift handle must be in its lowest position.
4. Insert the pins of the lift arms into the holes in the frame
rail (D) of the machine and secure with spring locking pins
(E).
Install Blade
1. Unlock park brake, put gear transmission in neutral or
pull out free-wheeling lever and push machine forward until
rear mounting bracket (A) of blade assembly is behind
drawbar (B) of machine.
2. Lock park brake.
3. Raise rear of blade frame and slide onto drawbar (C) of
machine.
4. Fasten with hitch pin (D) and large spring locking pin
(E).
5. Insert long end of each front stabilizer pin (F) into tube
of front stabilizer bracket (G).
6. Insert short end of each front stabilizer pin into front
mower mounting holes located on underside of front axle,
place spacer (I) over end of pin and secure with spring
locking pins (H).
Install Lift Links to Blade Frame and Lift Arms
1. Put lift lever one notch up from its lowest position.
A
C
D
E
B
M92905
A
B
c
CAUTION: Avoid injury! Lift lever is under
tension. Grasp lift lever securely and release
lock mechanism slowly.
E
C
D
F
G
H
I