Assemble rear support channels to thrust channel, Assembly – John Deere OMGX10902 I0 User Manual
Page 21
![background image](/manuals/130377/21/background.png)
Assembly - 17
ASSEMBLY
Assemble Rear Support Channels to Thrust
Channel
1. Install front stabilizer bracket (A) over thrust
channel (B).
2. Assemble one rear support channel to each side of the
thrust channel and fasten with four 3/8 x 1 in. hex
bolts (C) and four 3/8 in. nylock nuts (D) with the head of
the bolt to the inside. Hand tighten nuts only.
Assemble Lift Channel and Rear Mounting
Bracket to Rear Support Channels
1. Assemble the lift channel (A) to rear support
channels (B) with the open side of the lift channel upward.
2. Fasten lift channel with two 3/8 x 1 in. hex bolts (C), two
3/8 x 1 in. flat washers (D), and two 3/8 in. nylock nuts (E).
Hand tighten nuts only.
3. Slide rear mounting bracket (F) over rear support
channels (B) with the double holes to the rear and fasten
with four 3/8 x 1 in. hex bolts (C) and four 3/8 in. nylock
nuts (E). Hand tighten nuts only.
4. Place rear locating bracket (G) on top of rear mounting
bracket (F) and fasten with two 3/8 x 1 in. hex bolts (C) and
two 3/8 in. nylock nuts (E).
5. Tighten all hardware on rear support channels.
A
B
C
D
M92903a
A
D
C
E
C
B
E
E
G
C
F
M92904a