Assemble pivot latch strap, Install pivot control rod, Assemble blade pivot bracket and eye bolt – John Deere OMGX10902 I0 User Manual
Page 19: Assembly
![background image](/manuals/130377/19/background.png)
Assembly - 15
ASSEMBLY
Assemble Pivot Latch Strap
1. Insert 3/8 x 4-1/2 in. full thread bolt (A) through one side
of thrust channel (B), approximately half way.
2. Assemble one 3/8 in. hex nut (D) (non-locking) and 3/8
in. lock washer (C) onto hex bolt (A) approximately 1 inch
from head of bolt.
3. Place two pivot latch straps (E) together and fasten with
3/8 x 1 in. hex bolt (F) and 3/8 in. nylock nut (G). Insert
pivot latch straps through slot of the thrust channel and
onto the hex bolt (A).
NOTE: Bolt (A) must pivot freely after 3/8 in. nylock nut
(G) is assembled.
4. Assemble second 3/8 in. hex nut (D) and 3/8 in. lock
washer (C) onto 3/8 x 4-1/2 in. full thread bolt and hand
tighten against pivot latch straps. Adjust two 3/8 in. hex
nuts to allow hex bolt (A) to pass through other side of
thrust channel and fasten bolt with 3/8 in. nylock nut (G).
5. Fasten pivot latch straps (E) in the center of slot of the
thrust channel with 3/8 in. hex nuts (D).
Install Pivot Control Rod
NOTE: Pivot control rod (A) must be rotated from
pictured orientation in order to access grooved side of
spring locking pin hole.
1. Assemble pivot control rod (A) into pivot latch straps (B)
and fasten with two cotter pins (C) by inserting each
through the grooved side of the pivot control rod on each
side of pivot latch straps.
2. Assemble other end of pivot control rod (A) into hole of
pivot release bracket (D) and fasten with cotter pin (C).
Assemble Blade Pivot Bracket and Eye Bolt
1. Turn one 5/16 in. nut and lock washer assembly (A)
onto one 5/16 x 1-1/4 in. hex bolt (B) with lock washers
M93038
A
B
D
E
G
F
G
C
C
M93037
C
C
A
B
D
M93039
A
A
C
D
E
E
G
F
H
B
B