Assemble pivot plate to blade assembly, Assemble breakover return springs, Assemble pivot release rod – John Deere OMGX10902 I0 User Manual
Page 20: Assembly
![background image](/manuals/130377/20/background.png)
Assembly - 16
ASSEMBLY
away from the head of the bolt. Assemble two nuts and
bolts in this manner.
2. Place blade pivot bracket (C) on the left side of the pivot
plate (D). Insert bolt and nut assembly (A and B) and fasten
with another nut and lock washer assembly (E).
3. Install nut flush with end of bolt (B) and fasten to plate
with outside nut.
4. Install second bolt and nut assembly (A and B) into right
side of pivot plate and fasten with another nut and lock
washer assembly (E).
5. Assemble 3/8 in. hex nut (F) onto 2 in. eye bolt (G) and
turn it onto the eye end of the threads. Place wrench
through eyebolt to hold while tightening.
6. Assemble eyebolt to the blade pivot bracket (C) and
fasten with a 3/8 in. nylock nut (H). Loosen 3/8 in. lock nut
approximately 1/4 turn to allow eyebolt to pivot freely.
Assemble Pivot Plate to Blade Assembly
1. Lay blade assembly flat on the ground.
2. Install pivot plate (A) between the ribs (B) of the blade
assembly and fasten with two 1/2 x 1 in. hex
bolts (C) and two 1/2 in. lock nuts (D).
3. Loosen lock nuts (D) approximately 1/4 turn to allow
pivot plate to pivot freely.
Assemble Breakover Return Springs
1. Hook one end of the return spring (A) onto the anchor
bolt (B) of the blade assembly.
2. Using a box-end wrench (C) or spring puller hook it onto
the lower end of the return spring, press or pull down and
hook return spring over the spring anchor bolt (D) of the
pivot plate.
3. Repeat procedure for spring on other side of blade.
Assemble Pivot Release Rod
Assemble pivot release rod (A) down into pivot release
bracket (B) and fasten with spring clip (C).
M92900B
A
D
C
B
c
CAUTION: Avoid injury! Springs under
tension. Use caution when attaching springs.
M92901B
B
A
D
C
A
C
B