beautypg.com

Insignia NS-LCD32-09 User Manual

Page 3

background image

3

I have poor picture quality.

Make sure your cable connections are connected securely.

If you are receiving service from a cable or satellite provider, reception can vary by channel depending on the broadcast

power level of a given station. Contact your cable or satellite provider.

If you are using an antenna, the signal strength of the channel may be low.

o

Check the signal strength of the channel (Please note that the signal strength is only displayed on digital

channels):

ƒ Press

MENU. The on-screen menu opens.

ƒ Press

^ or v to select Setup, then press > to enter Setup menu.

ƒ Press

^ or v to select DTV Signal, then press > to view Signal Level display.

• If the signal level is Weak:

o

Make sure your antenna is connected securely to the TV.

o

Move the antenna around the room or close to a window.

o

Use a basic indoor set-top antenna designed to pick up both VHF and UHF.

OR

Use a set-top antenna that has a built-in signal amplifier.

OR

Use an antenna mounted on your roof or in your attic.

o

For more information about antennas and the available channels in your area, visit

www.antennaweb.org

.

• Press

EXIT to close the Signal Level display.

ƒ Press

EXIT to close the Signal Level display.

o

The UHF band (channels 14 and higher) is more directional than VHF (channels 2-13) and more sensitive to

obstacles (such as trees, tall buildings, and mountains) that lie between your antenna and the broadcast tower.
Getting good UHF reception can be more difficult than VHF.

o

If you're getting marginal reception of digital signals, both the picture and sound might freeze or break up to the

point that it's not watchable. If you're really on the fringes—either too far from a tower or with too many
obstacles in the way—you'll see a black screen that says "No signal."

o

Reception can vary by channel, depending on the location and broadcast power level of a given station.

The video cables you are using may be bad, try a new set.


I am missing channels or want to run an autochannel search.

It is possible that the Favorite button was pressed accidentally.

o

Press

the

Favorite button on the remote.

Make sure the channel is not blocked by Parental Controls.

Are you using a cable/satellite box, cable connected directly to the TV, or an antenna?

o

If you are using a cable or satellite box you must use the remote that came with that box to change channels.

ƒ Make sure you have the correct input selected to view channels via the cable or satellite box. For

example, if the cable or satellite box is connected via component cables please press input and select
Component 1 or Component 2 to view your channels.

ƒ Reception can vary by channel depending on the broadcast power level of a given station. Contact

your cable or satellite provider.

o

If you are using cable connected directly to the TV:

ƒ Try running an autochannel search:

Press MENU. The on-screen menu opens.

Press ^ or v to select Setup, then press > to enter Setup menu.

Press ^ or v to select Tuning Band, then press > to select Cable.

• Press

^ or v to select Auto Ch Search, then press > to begin searching for channels. Your TV

memorizes all cable channels you receive.

OR

Try manually adding the channel:

Press MENU. The on-screen menu opens.

Press ^ or v to select Setup, then press > to enter Setup menu.

Press ^ or v to select Manual Channel Set then press > to enter Manual Channel Set menu.

Press ^ or v to select the channel.

Press ENTER to toggle between Not Viewable and Viewable.