IBM eserver xSeries 330 - Manual (Page 22)

10 IBM® xSeries 330: Installation Guide
d. Push down on the blue adapter retention latch until it clicks into place,
securing the adapter.
e. Replace the expansion slot clip by sliding it down until it latches into place
and holds the adapter securely.
9. Connect the internal cables to the adapter.
Attention: Route cables so that they do not block the flow of air from the fans.
10. If you have other options to install, install them now.
11. Replace the cover on the server; then, reinstall the server in the rack and connect
all external cables. For more information on replacing the cover, refer to the User’s
Reference on the IBM xSeries Documentation CD.
12. Turn on the server.
Working with memory
Your xSeries 330 server supports 128 MB, 256 MB, 512 MB , and 1 GB DIMMs. See the
ServerProven list at http://www.ibm.com/pc/compat for a list of memory modules
for use with your server.
Memory considerations
Before you install memory, review the following:
Install additional DIMMs in the following order: DIMM connector 2, then 3, then 4.
(See the following illustration for memory connector locations.)
Note: The illustrations in this document might differ slightly from your hardware.
SCSI connector
(J4)
Extra cable
length
ServeRAID
adapter card