Removing the batteries from wheelchair, Installing batteries into wheelchair – Invacare TDX SP User Manual
Page 59
SECTION 10—BATTERIES
59
Removing the Batteries from Wheelchair
NOTE: For this procedure, refer to FIGURE 10.3 on page 59.
1. Slide battery tray with batteries out.
2. Disconnect the battery straps.
3. Unplug front battery from rear battery.
4. Remove the front battery.
5. Slide the rear battery forward and remove it from the tray.
FIGURE 10.3 Removing the Batteries from Wheelchair
Installing Batteries into Wheelchair
NOTE: For this procedure, refer to FIGURE 10.3 and FIGURE 10.4 on page 60.
NOTE: Positioning of the batteries into the battery tray is completed with battery tray positioned
in wheelchair and partially pulled out. Refer to FIGURE 10.3 for full view of wheelchair base.
Illustrations in FIGURE 10.4 on page 60 are shown without the wheelchair for clarification
purposes only.
1. Position the battery with battery connector bracket in the rear of the battery tray in the
orientation as shown. See Detail “A” of FIGURE 10.4 on page 60.
NOTE: Front of battery tray is designated by the battery stop. Rear of the battery tray is the
opposite end.
NOTE: Orientation of the battery is critical otherwise batteries will not connect to the controller
or each other.
2. Position the remaining battery in the front of the battery tray in the orientation shown
so that the wiring harnesses can be connected together. See Detail “B” of FIGURE 10.4
on page 60.
3. Connect front battery to rear battery. See Detail “B” of FIGURE 10.4 on page 60.
4. Connect battery straps. See Detail “C” of FIGURE 10.4 on page 60.
Disconnect Front Battery
from Rear Battery Here
FRONT OF
WHEELCHAIR
Rear Battery
Front Battery
Battery Straps
NOTE: Battery tray
shown removed for
clarity.
Battery Tray
NOTE: 22NF Batteries
shown.