beautypg.com

D optional ah-4, Operation, R warning: high voltage – Icom I706MKTMG User Manual

Page 31

background image

28

4

RECEIVE AND TRANSMIT

The AH-4 matches the IC-706MKIIG to a long wire
antenna more than 7 m/23 ft long (3.5 MHz and
above).

• See p. 14 for connection.
• See the AH-4 instruction manual for AH-4 installation and

antenna connection details.

NEVER operate the AH-4 without an antenna wire.
The tuner and transceiver will be damaged.

NEVER operate the AH-4 when it is ungrounded.

Transmitting before tuning may damage the trans-
ceiver. Note that the AH-4 cannot tune when using a

1

2

λ long wire or multiple of the operating frequency.

Note: The AH-4 can be used for HF bands and the
50 MHz band only.

AH-4 operation

Set the desired frequency in an HF band.

• The AH-4 will not operate on frequencies outside of

ham bands.

Push and hold [TUNER] for 2 sec.

• The [TUNER] light flashes and “CW” appears while tun-

ing.

The [TUNER] light lights constantly when tuning is
complete.

• When the connected wire cannot be tuned, the

[TUNER] light goes out, the AH-4 is bypassed and the
antenna wire is connected to the antenna connector on
the transceiver directly.

To bypass the AH-4 manually, push [TUNER].

• PTT tune function
The AH-4 is always tuned when the PTT is pushed
after the frequency is changed (more than 1%). This
function removes the “push and hold [TUNER]” oper-
ation and activates first transmission on the new fre-
quency. This function is turned ON in initial set mode,
item 13 (p. 54).

D Optional AH-4

AUTOMATIC ANTENNA TUNER

operation

AH-4 setting example:

For mobile operation

For outdoor operation

Long wire

Optional AH-2b
antenna element

RWARNING: HIGH VOLTAGE!

NEVER touch the antenna element while tuning or
transmitting.

Tuning is required for each frequency. Be sure to
re-tune the antenna before transmitting when you
change the frequency—even slightly.

USB

CW

Push [TUNER] for 2 sec.

CONVENIENT

This manual is related to the following products: