Novell netware driver installation, Initio – Initio I/O HIGHWAY User Manual

Page 40

initio

6 Select installation type.
7 Enter server name when prompted

At this point the boot files will be copied to the hard drive.

8 After the files are finished being copied you may encounter the following message:

Install found the following hardware but found

More than one driver supporting this hardware

PCI.XXXX.XXXX.XXXX.XXXX.XX

Press for a list of drivers to choose

From or to continue without selecting

Press to continue. Repeat if this screen is shown again.

9 A screen listing the drivers will be displayed. INI9100 will be listed as the selected

driver. This completes loading the Host Adapter Driver, Follow the on-screen direc-

tions to complete the Novell NetWare installation.

This will load the HAM driver. If a DSK driver is required or an updated HAM driver is

needed it is recommended that you complete the installation and use NetWares

INSTALL utility to update/change the driver.

Adding the Initio driver to an existing IntraNetWare sys-

tem

1 To begin the installation you will need to change the directory to the location of the

server and initialize the network server, e.g.,

Type CD \ NWSERVER

Type SERVER

2 At the NetWare prompt, Type LOAD INSTALL .
3 Select Driver Options from the window by highlighting it using the UP or DOWN

ARROW keys, press

Select Configure disk and storage device drivers from the window by high

lighting it using the UP or DOWN ARROW keys, press

4 Highlight Discover and load additional drivers and press
5 NetWare will load INI9100.HAM modify the STRATUP.NCF file to reflect the new

changes.

Novell NetWare Driver Installation