Microsoft windows nt driver installation, Initio – Initio I/O HIGHWAY User Manual

Page 36

initio

2 If you are installing Windows NT from a CD version, locate the Windows NT

Setup Disk for CD-ROM Installation. Make a backup copy of this diskette before

installation.

3 Insert the backup Windows NT Setup disk into drive A: and turn on your com-

puter.

4 Follow the instructions on the screen until you come to a window titled:

WINDOWS NT WORKSTATION SETUP

(for servers, it will read

WINDOWS NT SERVER

SETUP

Press ENTER to continue setting up Windows NT.

Select S to skip mass storage detection.

Select S to configure additional SCSI adapters.

5 When prompted by the Windows NT installation, scroll down the list and select

OTHER (Requires disk provided by a hardware manufacturer) from the

list of Additional SCSI Adapters. A message will appear on screen stating to:

Remove diskette in drive A and set it aside.

Insert

INI-9XXXU/9XXXUW DRIVER DISK 1

and press .

Select: Initio INI-9XXX SCSI Host Adapter and press .

6 The Initio host adapter driver is now installed The on-screen instructions will

continue for a complete installation of Windows NT. Refer to your Windows NT

users manual for completion of the operating system installation procedure.

Adding or updating the Initio driver to an existing Win-

dows NT system:

For computer systems using other SCSI host adapters or an IDE drive to provide the

system boot routine, these instructions will guide you through the INI-9XXX host

adapter driver installation. The Windows NT driver will be found on the

INI-9XXXU/

9XXXUW DRIVER DISK 1

. It is important that the SCSI bus hardware and Windows NT

are installed and configured before proceeding further.
1 Once a Windows NT session is established, use your installed mouse or the appropri-

ate key strokes to select MY COMPUTER from the Main Desktop. Execute the

following steps:

Select CONTROL PANEL from within the MY COMPUTER group.

Select SCSI ADAPTERS from within the CONTROL PANEL group.

2 Select the DRIVERS tab from within the SCSI ADAPTERS group.

In the DRIVERS window, select ADD

Microsoft Windows NT Driver Installation