Initio I/O HIGHWAY - Manual (Page 37)

33
initio
®
3 In the INSTALL DRIVER window, select “HAVE DISK...”.
4 In the INSTALL FROM DISK window that is displayed, enter the Initio Driver path
name:
• Insert INI-9XXXU/9XXXUW DRIVER DISK 1 into drive A:
• Type: A:\WINNT, select “OK”
5 Select Initio INI-9XXXU/UW PCI SCSI Host Adapter, select “OK” to install the
INI910U.SYS driver onto your hard disk drive.
6 In the WINDOWS NT SETUP window that is displayed, enter the Initio Driver path
name to continue:
• Type: A:\WINNT, select “CONTINUE”
7 This completes updating the Host Adapter Driver. Follow the on-screen directions to
restart you computer and activate the new driver
8 It is highly recommended that you verify Initio’s Windows NT device driver has been
properly installed by selecting MY COMPUTER from the desktop. Then select
CONTROL PANEL:
• Select SCSI ADAPTERS from within the CONTROL PANEL group,
• Select Initio INI-9XXXU/UW PCI SCSI Host Adapter from within the SCSI
CONTROLLER listing. If “This device is working properly” is displayed on your
screen, the driver has been correctly installed.
Installing a new Windows NT system and Initio driver
without floppy disks
For computer systems installing or upgrading to Windows NT from a floppyless setup
such as a share on your network, these instructions will guide you through the INI-
9XXXU/9XXXUW host adapter driver installation. The Windows NT drivers are located on
the INI-9XXXU/9XXXUW DRIVER DISK 1 . It is important that the hardware has been
installed successfully before proceeding further.
1 Execute a floppyless setup as described by the Windows NT System Administrator’s
Guide
Microsoft Windows NT Driver Installation