Sco unixware driver installation, Initio – Initio INI-9090U User Manual

Page 52

initio

2 When prompted to INSTALL HOST BUS ADAPTER DRIVERS, insert the

INI-9XXXU/

9XXXUW DRIVER DISK 2

into drive A: press .

3 When prompted to INSTALL ANOTHER HBA DISKETTE, press to con-

tinue.

4 Follow the directions on screen until you come to a window titled: Loading Initio INI-

9XXX Host Adapter.

Select CONTINUE INSTALLATION.

Select CONTINUE INSTALLATION again.

5 This completes loading the host adapter driver. Follow the on-screen directions to

complete the SCO UnixWare installation. For further information regarding UnixWare

installation, refer to the SCO UnixWare Installation Handbook.

Adding the Initio driver to an existing UnixWare system

1 Once a UnixWare session is established and a command prompt is ready, type (recall

that UnixWare is case sensitive):

cp /stand/unix /stand/unix.org , press

pkgadd -d diskette1 , press

2 Select i910u ihv hba from the list of available host drivers, press .

3 If the INI-9XXX is intended to be the bootable host adapter, the next step to updating the

driver will require a revision to the I910u file. These instructions will guide you through

changing the current software settings for UnixWare to establish the INI-9XXX as the host

adapter for your boot device:

At the system command prompt, type

cd /etc/conf/sdevice.d

Use vi or another editor to modify the file I910u by adding a line

locate the line $version2

edit the file by adding the line $static immediately following $version2.

Rebuild the UnixWare kernel by completing the following steps at the command

prompt :

/etc/conf/bin/idbuild -B

cp /etc/conf/cf.d/unix /stand/unix

cd /

shutdown -g0 ( 0 is Zero )

SCO UnixWare Driver Installation