Initio INI-9090U - Manual (Page 41)

37
initio
®
Upgrading/Changing Driver on an Existing IntraNetWare
Server
1 To begin the you will need to change the directory to the location of the server and
initialize the network server, e.g.,
Type CD \ NWSERVER
Type SERVER
2 At the NetWare prompt, Type LOAD INSTALL .
3 Select Driver Options from the window by highlighting it using the UP or DOWN
ARROW keys, press
• Select Configure disk and storage device drivers from the window by high-
lighting it using the UP or DOWN ARROW keys, press
4 Highlight Deselect a selected driver and press
5 Highlight the driver you wish to replace/upgrade and press
Repeat steps 4 and 5 for each instance of the driver
6 When all of the drivers you wish to upgrade/replace have been removed highlight
Select an additional driver and press
7 Press followed by
8 Enter the location path of the drivers A:\
9 Select the driver you wish to load INI9100.HAM or INI910U.DSK and press
If the HAM driver(s) are being used proceed to step 10. If you use the DSK driver
the upgrade is complete and you may exit the install utility.
10 Highlight Select and modify parameters and press
Enter the slot number and press to continue
11 Highlight Save parameters and continue and press
12 Repeat steps 6 through 11 for each additional adapter installed
Novell NetWare Driver Installation