Ibm os/2 driver installation, Initio – Initio INI-9090U User Manual

Page 44

initio

3 Using an appropriate text editor modify the CONFIG.SYS on the OS/2 Diskette 1 for INI-

9XXX to include the new Initio driver.

Enter: BASEDEV=INI910U.ADD and save the file.

* * * note place lines after set os2_shell=cdint.exe * * *

BASEDEV=AM201X8.ADD

set copyfromfloppy=1

4 Insert the Installation Diskette into drive A: and turn on your computer. This will

begin the OS/2 installation and establish an OS/2 bootable hard drive.

5 When prompted, insert the OS/2 Diskette 1 for INI-9XXX. Follow the on-screen

instructions to continue.

6 You have completed the Initio device driver installation for OS/2. Follow the on-

screen instructions and OS/2 manual for a complete description of OS/2 installation.

Adding the Initio driver to an existing OS/2 system

For computer systems using other SCSI host adapters or an IDE device to provide the

system boot routines, these instructions will guide you through INI-9XXX host adapter

driver installation. The OS/2 driver will be found on the

INI-9XXXU/9XXXUW DVR DISK 1

It is important that the SCSI bus hardware and OS/2 are installed correctly before pro-

ceeding further.

1 Once an OS/2 session is established, insert the

INI-9XXXU/9XXXUW DRIVER DISK 1

into your floppy drive.

2 By using your installed mouse, or by using the appropriate key strokes, select

DEVICE DRIVER INSTALL from the SYSTEM SETUP group.

3 Select CHANGE source directory to read as the root directory.
4 Select OS2 and select SET.
5 Select DESTINATION DIRECTORY.
6 Select CHANGE destination directory to any existing OS/2 directory or accept the

default.

7 Select SET.

IBM OS/2 Driver Installation