Installing the power cord (figure 2) – Invacare IRC5LXO2 User Manual

Page 57

PART

TWO

INSTALLING THE POWER CORD

(FIGURE 2)

1. Ensure the compressor is on a hard flat stable surface, such as a

table.

2. Plug the power cord into the electric connector in the back of the

compressor.

3. Plug the opposite end of the power cord into the wall outlet.

PROCEDURE 2

INITIAL SETUP

Wall Outlet

Power Cord

Compressor

(REAR)

Electric Connector

FIGURE 2 - INSTALLING THE POWER CORD

CONNECTING THE COMPRESSOR TO THE

CONCENTRATOR (FIGURE 3)

1. Insert one (1) end of the interconnect hose into the outlet fitting

on the back of the concentrator.

2. Insert the opposite end of the interconnect hose into the inlet

fitting on the side of the compressor.

NOTE: The metal tabs on the concentrator outlet fitting and the compressor

inlet fitting will pop out with an audible click when the end of the interconnect

hose is properly installed.
3. Loop any excess interconnect hose and secure to the back of the

concentrator with the fastening straps.