Intermec 6620 - Manual (Page 125)

SECTION 8 CMOS Setup
6620 Hand-Held Computer Technical Reference 8-11
"
Auto Suspend After:
Period of inactivity (standby) which results in the sys-
tem entering the suspend state — Disabled (default),
1, 2, 4, 6, 10, 14, 20, or 30 minutes.
"
Resume on Ring Indicate
Allows Ring Indicate (RI) to trigger a resume. If
ENABLED, RI causes a resume. If set to
DISABLED/APM (default), RI is controlled by
Windows 95 and only causes a resume if the feature is
activated by an APM 1.2 power driver.
"
Number of Rings
Whether RI is enabled, above, or enabled by an APM
1.2 power driver, this option sets the number of rings
necessary to cause a resume (wake the system) — 1, 3
(default), 5, or 7.
"
CRT Power Mode
Controls whether an external CRT is enabled. This
can be set to Auto (default), On, or Off, which bases
CRT power on the docking state.
"
Charge Triggers Resume
Allows the system to wake up when external power is
applied — On (default) or Off.
"
Aux Switch:
Auxiliary radio switch. “Auto” switches on when the
6620 Computer is docked; off when the 6620
Computer is undocked — On or Off (default).
"
Radio Switch:
Main radio switch. This allows the system to switch
between a local and remote antenna for LAN, WAN, or
GPS radios — Local (default), Remote, or Auto.
“Auto” dictates that the local antenna be used when
the 6620 Computer is undocked; and the remote
antenna be used when the 6620 Computer is docked.