IBM THINKCENTRE 8141 User Manual
Page 17
4.
Release
the
lever
2
securing
the
microprocessor
1
then
rotate
the
microprocessor
retainer
3
until
it
is
fully
in
the
up
position.
5.
Remove
the
microprocessor
from
the
system
board
socket
using
the
vacuum
pen 1 .
Important
Do
not
touch
the
gold
contacts
on
the
bottom
of
the
microprocessor.
If
you
must
touch
the
microprocessor,
touch
only
the
sides.
Notes:
a.
Take
notice
of
the
orientation
of
the
notches
on
the
microprocessor.
This
is
important
when
reinstalling
the
microprocessor
on
the
system
board.
b.
Do
not
drop
anything
on
the
socket
while
it
is
open.
Keep
all
contacts
as
clean
as
possible.
6.
Make
sure
that
the
lever
on
the
microprocessor
retainer
is
fully
in
the
up
position.
Replacing
customer
replaceable
units
(CRUs)
9
This manual is related to the following products: