Marantz SR5600 - Manual (Page 25)

21
ENGLISH
8 7.1 CH INPUT LEVEL
This sub-menu is to adjust the speaker levels for
7.1-channel input sources.
Here you will adjust the volume for each channel so
that they are all heard by the listener at the same
level.
1. Select “ 7.1CH INPUT ” in the SETUP MAIN
MENU with the or cursor buttons, and
press the
ENTER button.
2. To select “ VIDEO IN ”, press or cursor
button.
3. Using the or cursor buttons, select the
video input source which is emitted from
Monitor out in the 7.1 CH INPUT function.
The input source is switched by pressing the
or cursor buttons as follows;
LAST ↔ TV ↔ DVD ↔ VCR1 ↔ DSS ↔
AUX1 ↔ V-OFF ↔ LAST ↔
Notes:
• When select LAST, the source is set previous
source before 7.1 CH INPUT function is activated.
• When select V-OFF, no signal is emitted from
monitor out terminal.
4. To Select desired channel , press the or
cursor buttons.
5. Using the or cursor buttons, adjust the
volume level of each channel.
6. After you complete this portion of the set up,
move the cursor to “
MAIN ” with the or
cursor buttons and press the ENTER button.
Notes:
• These settings will be memorized to 7.1CH INPUT
source.
• This feature can be directly selected with the
CH.SEL button of the remote controller.
8 7 . 1 C H I N P U T L E V E L
V I D EO I N : L A S T
F RON T L : 0 d B
C E N T E R : 0 d B
F RON T R : 0 d B
S URR . R : 0 d B
S URR . B R : 0 d B
S URR . B L : 0 d B
S URR . L : 0 d B
S UB W : 0 d B
MA I N E X I T
LEVEL (VOLUME LEVEL):
Adjust the Multi-speaker output level with or
cursor button.
Note:
• This setting can be changed when the Surr Back is
set “NONE” in 2-1 SPEAKER SIZE menu.
When this setting is unavailable, “
✽✽✽” is
displayed
MAIN ROOM STATUS:
Selected input source in the main room will be
displayed.
Note:
• If “VOLUME” is set to “FIXED”, the multi-room
output level cannot be adjusted from the second
zone.
After you complete this portion of the set up, move
the cursor to “
MAIN ” with or cursor buttons and
press ENTER button.
9 SPEAKERS LEVEL SETTING
WITHOUT TEST TONE
Channel level (speaker level) can be adjusted
without using test tone.
Note:
• Four channel level settings can be memorized for
reproduction: the 7.1 ch input mode, CS mode,
Multi channel stereo mode, and all other surround
modes, respectively.
1. Set the surround mode or 7.1 ch input mode
which you want to adjust the channel level.
2. Press the CH.SEL button on the remote.
3. Select the desired channel (speaker) with the
or cursor buttons.
4. Adjust the level with the or cursor buttons.
5. After completing the setup, press the CH.SEL
button again.
C H L E V E L AD J U S T
F RON T L : 0 d B
C E N T E R : 0 d B
F RON T R : 0 d B
S URR . R : 0 d B
S URR . B R : 0 d B
S URR . B L : 0 d B
S URR . L : 0 d B
S UB W : 0 d B
05.6.3, 3:59 PM Page 21