Parental – Go-Video DV2130 User Manual

Page 34

Rating Control is a password-protected system that allows you to
block playback of DVDs based on their content. The system uses an
eight level rating system.
• If you try to play a DVD that exceeds the selected rating, an error

message will appear.

• Not all discs are rated.

Open “Initial Setup” menu

Press the SETUP button while the DVD is in Stop mode.

Select “DVD”

Use the

➐

❷

buttons to highlight “DVD”, then press ENTER to

select.

Select “Parental”

Use the

➐

❷

buttons to highlight “Parental”, then press ENTER to

select.

Select “Use Password”

Use the

➐

❷

buttons to highlight “Use Password”, then press

the

❿

button to select one of the following options:

• Off - No password is necessary to view a DVD or to change the

Rating Level. No additional settings are necessary.

• On - A password is necessary to view a DVD and to view the

Rating Level. The menu will change as shown.

NOTES:
• The first time “Require Password” is set to “Yes,” you will be

prompted to enter a new password.

• If the “Enter Password” screen appears, then “Require

Password” has already been set to “Yes.” Please skip to Step 5.

• There is no Default Password.

Enter Password

Use the number buttons (0-9) on the remote control to enter the
4-digit password.
• Write your password down, and keep it in a safe place in case

you need it to change your settings later.

Select “Rating Level”

Use the

➐

❷

buttons to highlight “Rating Level”, then press

ENTER to select.

Change Rating Level

Use the

➐

❷

buttons to select one of the following ratings:

• Level 8 Adult

• Level 4

• Level 7

• Level 3

• Level 6

• Level 2

• Level 5

• Level 1 Kids Safe

All ratings above the level you select will also be blocked, e.g., if
you block Level 6, then Levels 7 and 8 will also be blocked.
Press ENTER to confirm your selection.
• If you forgot your password, press power on from a cold start

with no disc in the unit. Press the REW and FF buttons
simultaneously on the front panel for 5 seconds. The “Reset OK”
message will appear. Press the POWER button and the
DVD+VCR will go to “Auto Setup” mode. (See page 13)

Parental