Furuno NAVNET 3D MFD8/12/BB - Manual (Page 15)

15
1.2. MFDBB Processor Mounting
The unit can be mounted on the deck, a desktop or on a bulkhead. Take special note
that the MFDBB IS NOT WATERPROOF. Select a mounting location considering the
points below:
• Select a location where temperature and humidity are moderate and stable.
• Consider the lengths of the cables connected among the processor unit, radar sensor
and control unit.
• For mounting on a bulkhead, be sure the mounting location is strong enough to
support the unit under the pitching and rolling normally encountered on the vessel.
• Leave sufficient space around the unit for maintenance and servicing. Recommended
maintenance space appears in the outline drawing at the back of this manual.
• A magnetic compass will be affected if the processor unit is placed too close to the
magnetic compass. Observe the compass safe distances in SAFETY INSTRUCTIONS
to prevent disturbance to the magnetic compass.
1.2.1. MFDBB Processor Desktop or Deck Mounting
Fasten with four self-tapping screws.