Hitachi 55PD5000 - Manual (Page 40)

38
OPERATING INSTRUCTIONS (continued)
SETUP MENU
Picture
Audio
Timer
Function
Setup
Language
Select
OK Set Setup
System
System 1
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set Return OK
Setup
System
System 1
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set Return OK
OK
MENU
OK
Setup
Colour System
AV1 Auto
AV2 PAL
AV3 SECAM
AV4 PAL
Select Return Exit
Setup
System
System 1
Colour System
Video Input
Audio Input
Scart Output
Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set Return OK
OK
Setup
Video Input
AV1 Auto
AV2 Composite/Component
AV3 Auto
AV4 S.Video
Select Return Exit
OK
Setup
Audio Input
AV1
Stereo
AV2 L/Mono
AV3 Stereo
AV4 L/Mono
Select Return Exit
Selected characters Setup hint
System System1 System2 System1 : Europe/Asia, System2 : North America
Colour System
AV1
Auto PAL SECAM
System 1
NTSC3.58 NTSC4.43
Auto NTSC-M
System 2
PAL-N PAL-M
This should correspond to the colour system of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
AV2
(Same to AV1) AV3
AV4
Video Input
AV1 Auto HDTV SDTV/DVD
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and the
operation is found erratic, set this to match the input signal.
AV2 (1st step) RGB Composite/Component
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
AV2 (2nd step) Auto HDTV SDTV/DVD This step should be set only when [Composite/Component] is selected on
the 1st step. And the procedure is same to AV1.
AV4 S.Video Composite
• If the signal from the equipment that is connected to AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.
▼
▼