Harbor Freight Tools 92772 User Manual
Page 11
Page 11
For technical questions, please call 1‑800‑444‑3353.
SKU 92772
Work Piece and Work Area Set Up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage. The
power cord must reach the work area
with enough extra length to allow free
movement while working.
3. Secure loose work pieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be objects, such as utility
lines, nearby that will present a hazard
while working.
General Operating Instructions
1. Squeeze and release the Trigger to put
it in its off position. If necessary, make
adjustments to the Speed Control Dial
(20) and Cutting Mode Selector (46).
Also if necessary, adjust the Base Plate
(41) for the desired bevel of cut.
2. Then, plug the Power Cord (43) into the
nearest 120 volt, grounded, electrical
outlet.
3. Position the Saw Blade (59, 60) of the
Jigsaw about 1/2” from the beginning cut
line on the workpiece. Do not allow the
Saw Blade to come in contact with the
workpiece.
4. Turn the Laser Switch (4) to its
“ON”
position, and align the laser beam with
the cut line on the workpiece.
5. Squeeze the Trigger to turn on the
Jigsaw. If operating the Jigsaw for an
extended period of time, you may wish to
depress the Trigger Lock (61) to lock the
Trigger in its
“ON” position.
6. Allow the Saw Blade (59, 60) to stroke
at full speed before feeding it into the
workpiece.
7. Make sure to hold the Jigsaw firmly with
both hands, as torque from the Motor
will cause the tool to twist. Then, slowly
make the cut .
(See Figure D.)
8. When finished, squeeze and release the
Trigger to put it in its off position and stop
the Jigsaw. Wait until the Saw Blade
(59, 60) stops completely. Turn the
Laser Switch (4) to its
“OFF” position.
Then, remove the Jigsaw from the
workpiece.
9. To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool indoors
out of children’s reach.