Hearth and Home Technologies SMART-BATT-II - Manual (Page 7)

7
NOTE: The remote receiver houses the microprocessor that
responds to commands from the transmitter to control sys-
tem operation. It emits one beep when it receives an ON or
OFF command manually, but no beep when cycling on and
off automatically in THERMO mode.
The remote receiver has a 3-position slide switch: OFF/RE-
MOTE/ON (see Figure 11).
Figure 11. Remote Receiver Slide Switch
NOTE: The remote receiver will only respond to the
transmitter when the 3-position slide button on the re-
mote receiver is in the Remote position. If the system
does not respond to the transmitter on initial use, see
section Matching Security Codes.
1. With the slide switch in the ON position, the system is
on.
2. With the slide switch in the REMOTE position, the sys-
tem only operates if the remote receiver receives com-
mands from the transmitter.
3. With the slide switch in the OFF position, the system is
off.
NOTE: The slide switch should be placed in the OFF posi-
tion if you will be away from your home for an extended
period of time. Placing the switch in the OFF position also
functions as a safety “lock out” by turning the system off
and rendering the remote receiver inoperative.
TRANSMITTER
Important: Before operating remote control, transmit-
ter and receiver must have matching security codes.
See section ‘Matching Security Codes’.
Important: Review ‘Thermo-Safety/Communication-Safety
Features’ under ‘Transmitter Safety Features’ section. These
signal/temperature safety features shut down the fireplace
system when a potentially unsafe condition exists.
Important: Review ‘Auto Shutdown’ section. This safety
feature shuts down the fireplace after 9 hours of continuous
operation, in ON mode only.
Important: New batteries are essential for proper opera-
tion of the multi-function transmitter. The transmitter oper-
ates on 2 AAA-size 1.5V batteries. Use Alkaline batteries
for longer battery life and maximum operational performance.
Insert 2 AAA-size 1.5V batteries into the battery compart-
ment on the back of the transmitter. When the batteries are
correctly inserted, the screen will display numbers (see
Figure 7 for LCD Display Screen).
NOTE: If the transmitter is activated from a very cold condi-
tion it may be necessary to allow the transmitter to stabi-
lize to room temperature (could take up to 15 minutes) be-
fore accurate room temperatures are displayed on the
screen.
NOTE: LCD screen is equipped with a “backlite” for easier
viewing of LCD screen. Backlite illuminates when a func-
tion button is depressed. After 5 seconds elapses, LCD
screen will return to its normal state.
BATTERY
COVER
WIRE
TERMINALS
ON/OFF REMOTE SLIDE SWITCH
LEARNING BUTTON