Heatcraft Refrigeration Products CLIMATE CONTROL CC-CUBZTB - Manual (Page 8)

8
3 - 22 HP C
ondensing Units
H
oriz
on
tal D
ischar
ge
Nomenclature
C B T 0000 L 6 C
Brand Compressor Application Horsepower Temp. Range Refrigerant Voltage
C =
Climate
Control
B = Bitzer T = Outdoor
N = Indoor
S = Beacon II
™
0401 - 4
0551 - 5
0601 - 6
0611 -6
0751 - 7.5
0901 - 9
1001 - 10
1201 - 12
1301 - 13
M = Med. Temp.
L = Low Temp.
6 = R-404A,
R-507
C = 208-230/3/60
D = 460/3/60
E = 575/3/60
Horizontal Air Discharge Condensing Units 4 to 13 HP
Standard and Optional Features
• Floating Tube™ coil design
• Rifled copper condenser tubing
• Designed for use with R-404A, R-507
• Prebent copper tubes minimize welded joints on
internal piping
• Fixed high and adjustable low pressure controls.
• Oil safety control
• Head pressure control valve
• Bitzer compressors with POE oil
• Spring mounted compressor with suction and discharge
vibration eliminators
• Crankcase heater
• Thermally protected, permanently lubricated ball bearing
condenser fan motors
• Separate subcooling circuit in condenser for added capacity
and vapor-free liquid
• Pressure relief valve on receiver
• Sealed liquid line filter drier and sight glass
• Electrical controls, including compressor contactor and
optional defrost control, are located in easily accessible control
box with a hinged cover
• Service Mate ™ module to assist troubleshooting
• Pumpdown Switch
• Cabinet is constructed from prepainted galvanized steel
• Base valve and high & low pressure taps on outside
of unit
• Vertical receivers
Factory-Installed Options
• Oversized receiver
• Replaceable core liquid filter drier
• Liquid line solenoid valve
• Suction filter
• Replaceable core suction filter
• Suction accumulator
• Oil separator
• Air defrost timer
• Electric defrost kits, including timer, evaporator fan contactor
with fusing, defrost heater contactor(s), lockout relay and
terminal strip
• Fusing for defrost kits
• Evaporator holdout relays for systems with multiple electric
defrost evaporators
• Low ambient kit with heated and insulated receiver with
time delay
• Fused disconnect switch
• Non-fused disconnect switch
• Phase-loss monitor
• Manual-reset high pressure switch
• Anti-short cycle timer
• Compressor circuit breakers
• Condenser fan cycling
• Coated condenser coils
• Copper finned coil
• Beacon II ™ compatible
• Hail guards (shipped loose)
• Compressor unloading
• NEMA contactors
• 12" extended legs for snowbelt region (shipped loose)
• Slanted louver for snowbelt regions (shipped loose)
• Dual pressure control