haier HWM62-0566 - Manual (Page 15)

13
Page 10
WATER LEVEL
water pressure and water level influence the wash time.
Push the SELECT button for 6 times, and it will resume the initial mode. It will circulate in that sequence.
When the "PROCESS/FUNCTION" button is on the "FUNCTION" state, push
-
"PROCESS/FUNCTION"button,it will circulate
as nether sequence:
Heavy wash
>heavy rinse->heavy spin->gental spin->heavy wash heavy rinse->heavy wash heavy spin->heavy wash
gentel spin->heavy rinse heavy spin->heavy rinse gentle spin->heavy wash heavy rinse heavy spin->heavy wash
heavy rinse gentle spin->heavy wash.
Procedure program selection method( PROCESS select state
Times of pushing the
PROCEE/PROGRAM
button
Selected procedure
programe Applicable circumstance
Contents (the lighted indicators
indicate the programs about to run)
WASH RINSE SPIN
standard program
When the common laundries need
washing, rinsing and spinning.
SOAK WASH RINSE SPIN
SOAK WASH RINSE SPIN
SOAK WASH RINSE SPIN
SOAK WASH RINSE SPIN
SOAK WASH RINSE SPIN
SOAK WASH RINSE SPIN
SPIN
(spin after drain)
When the laundries need only
spinning after manual washing
(first drain then spin)
The laundries are very dirty, or the
sleeves and collars of the shirt are
very dirty. First soak then wash.
SOAK WASH
RINSE
SPIN
WASH
(the washing liquid
remains in the tub)
RINSE SPIN
WASH RINSE
(the rinsing liquid
remains in the tub)
Repeat using the washing liquid
When prevent the laundries from
corrugating, and the laundries do
not need spinning
When the laundries need rinsing
and spinning after manual washing
Press " WATER LEVEL "button, select suitable water level
After switching on the power, when select the common and standard program, the washing
machine will execute fuzzy program automatically to detect the cloth. After defection, it can
set the water level automatically. To select other water level, first push the "start/pause"
button, then push the "water level" button to set the water level.
Push the "reserve" button to select
suitable reserve wash program
RESERVE
After switching on the power, the reserve program is set to off mode automatically. If you need to
set the washing procedure to be finished at reserved time, please push the " reserve " button to
set the reserve wash program. Refer to reserve button in Page 10 for selection
.
When the "reserve" function is activated, the indicator light of the program you have set
will be off. The "reserve (hours)" and "surplus(minutes)" indicator lights will be on. During
reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
Confirm the operation of reserve program
Push the "start/Pause" button
START/PAUSE
6 Finish washing
After Finishing wash ,the washing machine will cut off the power automatically