Hoover Power Nozzle - Manual (Page 5)

Check bag indicator
(Available some models)
q
There are three conditions that will
cause the indicator to become
completely red:
The bag is full; change bag.
2. Very fine materials (such as powder)
have been picked up, clogging the bag
pores; change bag, even if it is not full.
3. There is a blockage in the nozzle,
hose, tools or at the bag opening;
remove the blockage.
Suction regulator
q
The suction regulator (C) is located
on the hand grip and may be used
to increase or decrease suction for
various cleaning tasks.
If power nozzle is difficult to push on
some carpet, open the suction regulator.
This will prevent damage to the belt.
Cleaning tools
A variety of useful cleaning tools is
included with your cleaner. If the clean-
er you have purchased does not include
the wall/floor brush, it is available at a
nominal cost from your Authorized
Hoover Dealer (Depot), a Hoover
Factory Service Center or by writing to
The Hoover Company, North Canton,
Ohio 44720.
Select the proper tool
q
1. Crevice tool may be used in
tight spaces, corners and along
edges in such places as dresser draw-
ers, upholstered furniture, stairs and
baseboards.
2. Furniture nozzle may be used for
upholstered furniture, draperies, tapes-
tries, mattresses, clothing, automobile
interiors and carpeted stairs.
3. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, Venetian blinds,
baseboards, shutters and registers.
l 4. Wall/Floor brush may be used for
walls and very irregular hard surface
floors such as brick and slate.
*Included with some models.
For models with metal wands,
Attach tools to hand and
attach tools to wand by pushing
tic wands by rotating plastic latch
button projection on tool into spring
latch on wand. Depress center of latch
q
The cleaning tools are conveniently
stored in the cleaner, as shown. To
ring until slots align; insert tool and
rotate ring to lock.
To remove tool, reverse above procedure.
t o r e m o v e . replace the wall/floor brush, be sure to
turn the nozzle connector toward the
cord hook or rewind pedal (B) before
pushing the brush in place.
Continued
5