Honeywell CT8775A - Manual (Page 8)

69-1676—1 8
STEP 7. WIRE WALLPLATE TERMINALS
IMPORTANT
All wiring must comply with local codes and ordinances. If
unsure about household wiring procedures, call your local
heating/air conditioning contractor.
❑ Refer to the labels you placed on the wires when you removed the
old thermostat (see illustration).
❑ Match the letter of your old thermostat wire with the corresponding
terminal letter on your new thermostat. Refer to Table 2.
IMPORTANT
Remove the factory-installed jumper connecting terminals R
and Rc on the CT8775C Thermostat if wires will be con-
nected to both of these terminals.
❑ For wiring diagrams, see pp 16-17.
❑ Loosen the terminal screws. Slip each wire beneath its matching
terminal. Wraparound and straight connections are both acceptable,
(see illustration). Tighten the terminals.
❑ Plug the hole in the wall with insulation to help prevent drafts from
adversely affecting thermostat operation.
M19495
FACTORY
INSTALLED JUMPER
Y
G
R
W
M19496
FOR WRAPAROUND
INSERTION STRIP
7/16 IN. (11 MM).
FOR STRAIGHT INSERTION
STRIP 5/16 IN. (8 MM).