Harbor Freight Tools 32208 User Manual
Page 15
SKU 32208/32206
For technical questions, please call 1-800-444-3353.
PAGE 15
To Attach The Guide Post Guard:
1.
Remove the Knob Bolt (25B) which locks the Guide Post (24B) in
position. (See Figure X.)
2.
Align the two holes in the Upper Guide Cover (83B) with the Knob Bolt hole (25B)
and the hole located at the bottom/front of the Upper Frame Arm (1B).
3.
Attach the Upper Guide Cover (83B) to the Upper Frame Arm (1B), using the Hex
Bolt (86B), the Washer (85B), and the Lock Washer (87B).
4.
Replace the Knob Bolt (25B). Adjust the Guide Post (24B) to the desired height,
and securely tighten the Knob Bolt.
To Adjust The Angle Of The Table:
1.
The Bandsaw is equipped with a Table (36B) capable of being adjusted up to 15
0
to the left and up to 45
0
to the right. (See Figures Y* and Z*.)
2.
To adjust the Table (36B) to ensure the Table is 90
0
to the Saw Blade, loosen the
two Knobs (15B) which are located on the underneath of the Table.
3.
Tilt the Table (36B) to the left or right until the Needle points to “0” on the Scale
(40B). Then, securely tighten the two Knobs (15B).
(*Figures Y and Z see page 16.)
REV 04/02
FIGURE X
FIGURE W