Harbor Freight Tools 32208 - Manual (Page 11)

SKU 32208/32206 For technical questions, please call 1-800-444-3353. PAGE 11
To Install The Saw Blade:
Wear Gloves; be careful of sharp blade teeth when handling.
1. Remove the four Knobs (15B) from the Upper and Lower Wheel Guards (14B, 21B).
(See Figure P.)
2. Remove and set aside the Upper and Lower Wheel Guards (14B, 21B).
3. Remove the Table Insert (37B) and Table Pin (38B). (See Figure Q.)
To Install The Side Panels To The Stand:
1. With a Philips screwdriver, start the Tapping Screws (40A) into the Relief Stops
(39A). (See Figure N.)
2. Attach the Relief Stops (39A) to the Side Panel (38A) by partially screwing the Tap-
ping Screws (40A) into the mounting holes on the Side Panel. The Stops are high-
lighted in Figure O - step 1.
3. Position the Relief Stops (39A) so that the Stops (39A) point towards the center of the
Side Panel (38).
4. While holding the Side Panel (38A) by the two finger holes, place it inside the side of
the Stand as shown in Figure O - step 2. Rotate the Relief Stops (39A) out and
screw in the Tapping Screws (40A) to secure the Side Panel in place. Repeat the
process for the other Side Panel (38A).
FIGURE N
FIGURE P
FIGURE Q
38B
37B
REV
07/04
FIGURE O
Step 1
Step 2