haier AD422BMBAA - Manual (Page 10)

Timer On/Off function
Operation instruction
TIMER ON TIMER OFF TIMER ON-OFF
Blank
SET
ON/OFF
MODE FAN SWING
TEMP
CLOCK SET
TIMER SLEEP
RESET
FILTER RESET
Before using TIMER function, calibrate the
clock first (referring to page 3). When you
wake up in the morning, before going back
to home after work or after going to bed, you
can let your air conditioner automatically turn
on or turn off.
2.Set of TIMER mode
Press the TIMER button to change the
TIMER mode, each press the TIMER mode
will change as the following sequence:
1.Turn on the unit
Cancel TIMER
Press the TIMER button several times until the TIMER mode display
disappears.
After turning on the unit, set the desired
working mode.
The LCD of the wire controller will show working
mode. (except for Timer, Sleep, Swing)
* Each press, the set time increases 10 minutes. If depress the button, the time will
increase rapidly.
* Each press, the set time decreases 10 minutes. If depress the button, the time will
decrease rapidly.
3.Set time
Press the time adjusting button
This LCD will show the time set, the time can be adjusted within 24h.
(AM stands for morning, PM stands for afternoon).
4.Confirm the time
After calibration of the clock, press SET button to confirm time.
The time displayed is: at x oíclock x minutes the unit will be turned on
(TIMER ON) or turned off (TIMER OFF).
Hints:.
After power failure, the clock should be calibrated again.
The wire controller has memory function, when you use this function for the
second time, if the time set is the same as the previous one, you just need to
choose the TIMER mode then press the SET button to confirm.
OFF ON OFF ON
AM
PM
AM
PM
Then choose the timer mode as you need
(TIMER ON or TIMER OFF.)
At this time the or will flash.
ON OFF
* * * *
At this time, the * * or * * will not flash. ON OFF