Hotpoint X156G - Manual (Page 20)

Installation Instructions
20
Unpack the components from inside the grill and oven.
Check that the following parts are present:
Grill pan and grid Grill pan handle
Pan supports (2) Oven shelves (2)
Enamelled discs (4) Aluminium burner bodies (4)
Literature Model X156G only: Battery 1.5V
Four skid feet are fitted which can be adjusted up or down to level
the cooker.
Caution:
Some soft floor coverings may get damaged if the cooker
is not moved carefully.
The cooker must be fitted with a stability device firmly secured to
the fabric of the building. One of the holes in the rear panel can be
used to engage a stability bracket.
The bracket must be
fitted to the wall behind the
cooker. The diagram is a
guide to the correct height
at which the bracket should
be from the floor.
The cooker is designed to match the depth of standard 600mm
worktops. An adaptor backplate should, therefore, be fitted within
the shaded area shown to allow the cooker to be pushed fully to the
wall. If a forward facing backplate is used, it must be chased into
the wall.
Connection to the cooker should be made with an approved
appliance flexible connection to BS 669. A length of 0.9 to 1.25m is
recommended. The length of hose chosen should be such that when
the cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are
likely to come in contact with the flexible hose do not exceed 70˚C.
Unpacking the
Cooker
Levelling
Stability Bracket
Connecting To
The Gas Supply
155mm
Floor to bracket.
250
680
250
500