Hoover S2200 - Manual (Page 9)

9
3-14
3-15
3-16
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, Hoover
part No. 27313101.
Reattaching filter door
The filter door is designed with a
“break-away” feature which allows it to
snap free if it is pushed open too far.
To reattach, align hinges (O) of cover
with slots on sides of filter area.
Press door back into place.
Check brush roll
channels
Because your cleaner picks up so well,
we strongly recommend you check for
debris accumulation in the channels
next to the brush roll
when you check
the filters. Removing this debris will
help maintain your cleaner’s excellent
pick up and suction. Remove debris as
follows:
Disconnect cleaner from electrical
outlet.
Check for debris accumulation by
removing bottom plate (Fig. 3-18) and
looking in the channels next to the brush
roll (Fig. 3-27).
Remove any accumulation.
Reposition bottom plate (Fig. 3-22).
3-10 3-11 3-12
M
L
To re-assemble filter assembly, place
large knob of HEPA cartridge filter in
hole on bottom of pre-filter.
Snap top of HEPA cartridge filter into
place.
Align grooves (L) on pre-filter frame with
ribs (M) in dirt cup. Slide filter assembly down into cup until
a light snap is felt. Gently pull up on
assembly to ensure that it is seated
properly in the cup. Ensure that no part
of pre-filter screen extends above top
edge of dirt cup.
Close lid and return cup to cleaner (Fig.
3-5).
Note: If dirt cup lid does not close all
the way, first ensure that filter assembly
is pushed down all the way. Then, turn
knob on lid slightly until lid closes (see
Fig. 3-3).
3-13
N
O
Final filter
Replacing final filter
The final filter assists in the filtration
process to return clean air to the room.
To replace this filter when it becomes
dirty, open the door on the side of the
cleaner. Remove filter (N) and discard.
Reposition new filter on the side of
cleaner. Make sure the white side of the
filter faces outward. Close door.
Should you want to replace this filter,
ask for part
No. 40110006.
Do not operate cleaner without the fil-
ter in place.
Removing lens
Disconnect cleaner from electrical
outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.
Installing bulb
Pull old bulb straight out of socket. Push
new bulb straight into socket until locked
in place
Excessive force is not required.
Replacing lens
Reposition lens and secure with the two
screws.
Continued
3-17