HP RC5240P - Manual (Page 21)

chapter 1 19
Connections and Setup
How to Find Your TV’s Video Input Channel
You need to tune your TV to the Video Input Channel (or S-Video Channel if you connected the S-Video
cable to your TV and to your DVD Player) to see the DVD Player’s menu and to see the content that’s on a
disc. The video channel on TVs varies for different brands and different models. In order for your DVD remote
to work, your TV must be set on the correct video input channel.
• If your TV brand is RCA, GE, or PROSCAN, press the TV button on theremote. Then press the INPUT
button on the remote.
• If you have another brand, consult your TV’s Owner’s Manual.
If those options don’t work, try one of the following options.
• Press a button on the remote (see table below).
• Select it from the TV’s menu system.
• Tune directly to the DVD input channel by pressing a specific number (see table below).
• Go through all the channels in the channel list by pressing the channel up/down buttons on the TV.
Some common scenarios are listed in the following table:
Video Input Channel Variations
Button/switch Button on the Channel #
on the TV TV Remote
VIDEO VID 1 00
SIGNAL LINE 90
VID 1 VID 91
VID 2 VIDEO 92
S-VID S-VID 93
S-VIDEO INPUT VID 1
S-VIDEO VID 2
SOURCE
AUX
15739290.03 s&c 4/19/01, 4:24 PM 19