Honeywell BEDIX/KING GPS RNAV User Manual
Page 12
BENDIX/KING
KLN 90B
Page 1-6
10521I05.TDC
Rev 5, April/2003
Table 3-7 KLN 90B Signal Inputs
Table 3-8 KLN 90B Gray Code Inputs
GPS DISPLAYED:
OPEN = GPS displayed (when an indicator resolver is
connected to the OBS resolver inputs)
GND = GPS not displayed (when an indicator resolver is
not connected)
TAKE HOME:
OPEN = Normal Operation
GND = Take Home Mode
SDI 1/2:
OPEN = Primary Long-range Navigation System
GND = Secondary Long-range Navigation System
EFIS 429 RCVR inputs:
RDRG (Radar Graphics)
429 inputs:
AIR DATA 429 Inputs:
ARM SELECT:
This pin is used as a mode programming pin on power-up
and later as a select input.
LEG/OBS CONTROL:
This pin is used as a mode programming pin on power-up
and later as a control input.
DATA LOADER IN:
The Data Loader RS 232 input is designed to communi-
cate with the dataloader
RS 232 IN:
The RS 232 input is designed to communicate with devic-
es, i.e. air data and fuel flow sensors via RS 232 format
(refer to
ALT ALERT:
ENABLED = Open (or tied to A/C Power thru a passive
load)
DISABLED = GND (This pin also functions as an output,
refer to
for details)
(A1,A2,A4,B1,B2,B
4,C1,C2,C4,D4)
Gray Code Altitude Signals (0 V. to 28 V.) These inputs are diode
isolated inside the KLN 90B on all units above S/N 1542
OBS RES SIN:
OBS resolver sine, nominal input impedance = 36.5 K ohms (ac)
and 100 K ohms (dc)
OBS RES COS:
OBS resolver cosine, nominal input impedance = 36.5 K ohms
(ac) and 100 K ohms (dc)