haier HDT18PA User Manual

Page 12

Note: Use only manufacturer's recommended "Automatic Dishwasher Detergent" only

for your dishwasher. Other types of detergents that are not for dishwasher use

may cause oversudsing and foaming. Do not use detergents that are dried,

caked or moist. These types of detergents will not dissolve properly and clean

effectively.

1. Make sure all items are loaded in the racks properly.

2. Pour in detergent into open compartment that is located on the inside of the door.

3. Close the door and latch safely.

4. Select the desired wash cycle.

5. Press "ON" button to start the wash process.

6. Select "Vented Dry" button if you want to dry after the wash cycle is finished.

Note: To add or remove items after cycle starts, unlock the door latch and wait a few

seconds until wash action has stopped. Open the door and let hot steam inside

the dishwasher out. After the hot steam is completely released, you can now

add or change items. Once you make your changes, close the door gently and

lock the door latch to resume the cycle..

Selecting Wash & Dry Cycle:

Check List for Wash Process:

For your convenience, your dishwasher has two wash cycles, normal and heavy.

You also have two options, "vented dry On/Off" and "rinse & hold". You can

select your desired wash cycle depending upon the type of dishware and whether

they are heavily or lightly soiled.

Normal Wash Cycle:

This is used for regular loads for medium soiled dishware, silverware and glassware.

The total time for "Wash Only" cycle is approximately 27 minutes. When "Dry Cycle"

is selected, the total time for the whole cycle will be approximately 42 minutes.

Heavy Wash Cycle:

This cycle is used for heavily soiled dishware, glassware, silverware and pots &

pans, and cookware with dried soils. The total time for "Wash Only" cycle is

approximately 42 minutes. When "Dry Cycle" is selected, the total time for the

whole cycle will be approximately 53 minutes.

Vented

Dry

Rinse

Hold

Normal

Heavy

HDT18PA