Honeywell CT2700 - Manual (Page 5)

69-1085
5
CT2700 AN ELECTRONIC ROUND ™ PROGRAMMABLE THERMOSTAT
Press the thermostat straight on to the wallplate to
latch.
NOTE: To remove the thermostat from the wallplate,
grasp the thermostat on both sides and pull the
thermostat straight out.
Restore power to the heating/cooling system.
7
PROGRAM YOUR THERMOSTAT
The thermostat is preprogrammed for your convenience
with the following time and temperature settings,
see Table 2.
Table 2. Preprogrammed Time/Temperature Settings.
Period
Start
Time Heating
Setpoint
Cooling
Setpoint
WAKE 6:00 AM 70°F (21°C) 78°F (25.5°C)
SLEEP 10:00 PM 62°F (16.5°C) 82°F (28°C)
WAKE is the time period you want the house at a comfort-
able temperature during the day.
SLEEP is the time period you can set for an energy-
savings temperature while you are sleeping.
NOTE: The heating and cooling program times are the
same. Changing your cooling WAKE time also
changes your heating WAKE time.
The following sequence uses the heating program as an
example; the System switch is in the HEAT position. To
change to the cooling program, move the System switch to
the COOL position and enter the cooling temperature
settings.
NOTE: To exit the sequence at any time, press
until End is displayed.
1. Set Current Time
a. Press .
b. Press or
to set current
time.
If you wish to change the preprogrammed time/ tempera-
ture settings, follow steps 2 through 6. If not, press the
key until End is displayed or the thermostat will
automatically return to normal operational mode within five
minutes.
2. Set WAKE Time
a. Press .
b. Press or
to set desired
WAKE time.
PM
AM
3. Set WAKE
Temperature
a. Press .
b. Press or
to set desired
WAKE temperature.
4. Set SLEEP Time
a. Press .
b. Press or
to set desired
SLEEP time.
5. Set SLEEP
Temperature
a. Press .
b. Press or
to set desired
SLEEP temperature.
6. Run Program
Press . End is
displayed for five
seconds indicating the
end of programming.
The thermostat then
displays the current
time and room
temperature.
8
OPERATE YOUR THERMOSTAT
Display Temperature Setting
a. Press or once
to display present
temperature setting.
After approximately
five seconds, the
thermostat displays the current time and room
temperature.
Temporary Change
a. Press or until
the desired tempera-
ture is displayed.
b. TEMPORARY is
displayed.
The TEMPORARY
change is in effect
until the next program
period.
NOTE: To cancel your TEMPORARY change, press
until End is displayed.
AM
SET
PM
PM
SET
PM
TEMPORARY
AM
SET
AM
SET
AM