Hunter Fan Type T Models - Manual (Page 7)

7
42747-01 • 09/21/07 • Hunter Fan Company
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
4-1. Make sure the power to the outlet box and associated wall switch
location is still OFF.
4-2. To connect the wires, hold the bare metal leads together and
place a wire connector over them, then twist the wire connector
clockwise until tight.
4-3. Connect the bare or green ground wired (grounded) from the
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
4-4. Connect the white wire (ungrounded) from the ceiling to the
white wired (ungrounded) from the fan.
4-5. Connect the remaining wires as follows:
Single Switch Wiring:
• The black wire from the ceiling to the black and the black/
white wire from the fan.
Dual Switch Wiring:
• The black wire from the ceiling to the black wire from the fan.
• The black/white wire from the fan to the wire for the wall
switch.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
4-6 Turn the splices upward and push them carefully back through the
ceiling plate into the outlet box.
4-7 Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the
outlet box.
4 • Wiring the Fan
Wire
connector
Step 4-3
Step 4-4