Harbor Freight Tools Central Pneumatic AIr Nailer/Stapler 2-in-1 Kit 97525 - Manual (Page 7)

SKU 97525 Page 7 For technical questions, please call 1-800-444-3353.
Anytime any maintenance or repairs are done (including clearing jams), FIRST:
1. Disconnect the Nailer/Stapler from the air hose.
2. Empty Magazine A (61) completely.
3. Attempt to fire the Nailer/Stapler into a piece of scrap wood to ensure that it is
disconnected and is incapable of firing any staples.
4. Always leave Magazine A (61) open during maintenance. The Magazine is spring-
loaded and may cause parts or a fastener to fly out of the Nailer/Stapler.
Clearing Jams
1. Disconnect tool from air hose, empty Magazine A
(61) of fasteners, release any built-up air pressure,
and leave the magazine open, as explained above.
2. While doing this step and the next 2 steps, hold the
Nailer/Stapler pointed away from you and any other
people or fragile objects - see Figure 1. Remove all
three Safety Cover Bolts (48) on the Safety Cover
(47) - see Figure 2.
3. Lift the Safety Cover (47) off the top of the Nailer/
Stapler - see Figure 3.
4. Carefully slide the Driver Cover (50) off around the
Safety (42). Note the position of the tab on the Driver
Cover (50). Remove the jammed fastener; pliers
may be necessary to remove a stuck fastener.
5. Inspect the Driver (17A) for bends or breakage. If
it is damaged, do not use the tool until it is repaired
by a qualified technician.
6. Lightly oil the Driver (17A) and replace the Driver
Cover (50) with the tab in the Cover facing the Driver
Guide (52). Replace the Safety Cover (47), being
careful to line up the bolt holes and fit the Safety
(42) into the slot. Replace and securely tighten all
of the Safety Cover Bolts (48). Make sure that the
Safety (42) moves without sticking.
7. Reload the Nailer/Stapler.
8. Reconnect the Nailer/Stapler to the air hose.
9. Press the Safety (42) of the Nailer/Stapler against
an appropriate piece of scrap wood.
10. Test fire the Nailer/Stapler several times, checking
for proper operation.
11. Disconnect the Nailer/Stapler, remove the fasteners,
and store the Nailer/Stapler in a location out of
children’s reach.
FIGURE 1
FIGURE 2
Safety
Cover (47)
Safety Cover
Bolts (48)
FIGURE 3 Safety
(42)
Safety
Cover (47)
FIGURE 4
Safety
Cover (47)
Driver
Cover (50)
tab