Operation – Hunter Fan 47300A User Manual

Page 34

Text mode
Original mode

OPERATION

SPAN Setting Mode

Your thermostat is set at the factory to cycle at
0.5˚C (1˚F) above and below the set temperature.
(Span = 2) This setting has been designed to pro-
vide a comfortable room temperature under most

all conditions. However, if you find your system
cycling too fast or too slow, then the Span can be
adjusted to modify the cycle time.

■ Press and hold BOTH for three seconds. The display

will flash, and SPAN will be displayed on the LCD.

■ Press to raise the Span to 3. This setting INCREASES

the cycle time by allowing your system to run
LONGER.

■ Press to lower the Span to 1. This setting

DECREASES the cycle time by causing your
system to run SHORTER.

41665-01.pmd

9/30/03, 5:40 PM