Humax F3-FOX CI - Manual (Page 38)

**
In order to maintain proper performance of the product, it is essential to have the most up-to-date software.
**
1. OTA (Over the Air)
OTA, an abbreviation of Over–the-Air, is a standard for the transmission of software for equipment through a broadcast system.
Over the Air (OTA) is simply an alternative method for downloading software versions. However, the operator reserves the right to
decide when and where this software update can take place over the antenna.
The software update will only occur under the following circumstances:
**
1. The equipment should have appropriate loader software.
Caution: Please note that if you don't have normal loader software, the equipment may not be updated or work after
software update.
2. The operator decides to release the software via a designated antenna system.
3. The equipment must be tuned properly to the same channel that the operator uses.
4. Upgrade software when the quality of receiving signal strength is high.
**
Caution:
•
Please be careful to keep the power on and the power cord plugged in during software update. If the power is off during software
update, it may cause fatal damage to the product.
• Please be careful not to pull out the Signal line during software update. Update may be interrupted and the product may not work.
GB 37