Humax F3-FOX CI - Manual (Page 18)

**
4.2 Manual Search
You can search services of the selected satellite by transponders if you know the transponder information.
**
• Antenna Alternative: Select antenna alternative which has different
combinations of settings for search. Antenna Alternative 16 is predefined for
SMATV.
• Frequency: Enter transponder frequency.
• Polarisation: Select the type of polarisation.
• Symbol Rate: Select or enter transponder symbol rate.
• FEC: Select FEC (Forward Error Correction).
• Network Search: If you want to search services for multiple transponders,
select "Yes". Otherwise, select "No".
• Automatic Skip: When skipping all scrambled service search, select "Yes".
Otherwise, select "No".
• Advanced: In advanced mode, enter Video Packet ID (PID), Audio PID,
and PCR PID.
**
After setting the parameters of search, press the OK button to start service search. Wait until the operation is completed. After finishing
search operation, the result window will be displayed. You can delete the services using the
and the RED button. To cancel
deleting operation, press the RED button again. The screen also shows the number of the services found and the transponder
information.
To save the found services, press the OK button.
**
Note:
•
If the antenna is properly set up, the signal strength bar and quality bar level, located at the bottom of the screen moves up.
• Press the EXIT button to stop search operation.
• When you press the i button after selecting "USALS" in Motorised System, USALS Setting screen will appear.
GB 17